Simes s 4655w 14 step led 930 gr

TYPE Wall-mounted luminaire Protection degree IP 65 MATERIAL CHARACTERISTICS Body in extruded primary aluminum EN AW-6060 and die-cast EN AB-47100 with high resistance to oxidation Tumbling process to prepare for the painting phase A4 stainless steel screws strong molybdenum content 2.5-3% Annealed silicone gaskets Extra-resistant double painting carried out in 3 phases: 1) BONDERITE treatment with chemical protection of metal-free fluozirconic material containing ceramic nanoparticles that create a cohesive, inorganic, high density layer 2) PRE-POLYMERIZATION cycle with application of the epoxy primer with characteristics of overpainting on the device and high resistance to oxidation thanks to the presence of zinc 3) POLYMERIZATION cycle with the application of polyester powder with high resistance to rays UV and atmospheric agents, with resistance to the salt spray test of 1200h Mechanical resistance IK 06 LIGHTING PERFORMANCE Optical reflector in white plastic material Transparent tempered protective glass, 4 mm thick Light source, with fixed lamp position Efficiency -- The upper part of the The fixture has a grille that acts as a radiator, to dissipate the heat developed by the LED positioned right underneath. INSTALLATION AND MAINTENANCE The casing has a depth reduced to a minimum: with its 70mm, in fact, it can also be walled into partition walls. Made of polypropylene, it can be installed flush with the floor, or at a height of approximately 20cm from the ground, depending on the desired effect. The lamp unit is completely extractable via a spring mechanism; this simplifies maintenance operations, but makes it more suitable for use in environments where there is no risk of vandalism